• +41 (0)61 836 15 30
  • info@avintos.ch

components

Barcode Scanner

Barcode Scanner

Each Equflow flowmeter has a K-factor, which is the amount of pulses generated when 1 liter of water goes through the flowmeter, with a flow that is within the flowmeter’s flowrange. This value can be different for different flowmeters, even if they have the same product code. Exchanging a flowmeter would thus require the operator to enter the new K-factor in their equipment.
The Equflow 6110 Barcode scanner is designed to convert the output of each flowmeter to a user-defined value. This pre-set value has to be entered only once. Upon exchanging the flowmeter, scanning its barcode is all that is needed for the barcode scanner to convert the signal.
This barcode scanner is typically used in combination with an Equflow flowmeter and a (third party) device, for which the digital signal will be converted.
Advantages of using the Equflow 6110 Barcode scanner
• Scanning the barcode takes only a second, and will thus be much faster than changing the settings in your controller, while maintaining the same accuracy and repeatability;
• Reduce the chance of errors that could occur when manually entering the K-factor;
• Correction of the K-factor at up to 5 flowrates over the entire flowrange is possible, this increases the accuracy at the higher and lower end of the flowrange.

pdf6110_Barcode_Scanner_052019.pdf

MOVIE Barcode Scanner - 1080p

Date

19 September 2019

Categories

Instruments

About Us

At avintos we have the ambition to become your first choice as a supplier of single use assemblies
 
From your inquiry through to our delivery. Your need is our motivation.

Contact us

avintos AG, Weidenweg 17, CH-4310 Rheinfelden

+41 (0)61 836 15 30

This email address is being protected from spambots. You need JavaScript enabled to view it.

Our Social Numbers

© 2017 avintos AG. All Rights Reserved.

Search

Cookies make it easier for us to provide you with our services. With the usage of our services you permit us to use cookies.